box clutch

I've always found it cumbersome and finicky to make the last adjustments to fine tune clutch engagement. I made a tool to help separate the nuts on the slave cylinder actuator rod. Started with a piece of 1.5" square tube, cut and notched it to 13mm, bent it to shape. If you rotate the rod so...

With a new crunch between 1 and 2 I was worried that the clutch was not bled well enough after a revision of the pedal box. So i started to bleed it over and over again, but without results. It might as well be the synchromesh. But it made me think about the clutch dynamics. On the forum there...

Guys, what is the correct method to adjust the clutch slave rod on a 1500? Having just been through the process on my 1300 after swapping the slave cylinder my 1500 has come out in sympathy and started leaking from the slave. The 1300 was easy to setup but the 1500 looks different and I can’t...

Working on the "dog bed" as my wife puts it (as in it's the same size lol).....clutch and brake hydraulics at the moment replacing pretty much everything from the reservoir on down for the brakes and clutch...new masters (and slave for the clutch)......new hose.....everything going well.... I...

Seeing the new thread reminded me I've been meaning to post about my concern - my clutch engages with the pedal very close to the floor. I have in the past replaced the slave / hydraulic line / rod & the actual clutch, and the pivot bushing in the bell housing. I don't recall if it has always...

These can be a real problem to install. https://www.youtube.com/watch?v=f-Tn90QAayc&list=UUwh_UaR9_fgy97tZynvKs-w Bernice

Hi, Everybody. Although I am newly registered, I have been following the x-web forum for about 4 years now. I have always remained silent because I had nothing of true value to add to this forum......however.....I had to share this with everybody out there, as I can see that bleeding the clutch...