Question on V-ring seals

[KBabcock]

I'm planning to put the bearings in the front hubs soon and want to confirm the correct direction of the v-ring seals half the seal is like a regular washer while the other half has a short cone type structure (The V in V-ring I assume). See picture below. I also assume the cone side faces the bearing face's? Is that correct?

 

[Ics19]

. I also assume the cone side faces the bearing face's? Is that correct?

Yes, that's correct. The square section fits onto the hub or washer. Good write up with pictures here:

Rear (and Front) Wheel Bearing Replacement (5spd).

Picking up from this thread. Rear Bearings are 37x37x72mm. You can use Fiat 500 front wheel bearings for the rear. I had to redo one rear wheel bearing from 2015, and replace the other side original (137K miles) Fiat diagram. Plate (#5) is actually between 1 & 2, since it installs from the...

xwebforums.com